Aerated brick mill equipment analysis of the oil spill problem first case: Analysis: After the mill running for some time, the injection pipes spray holes are blocked some impurities in the oil, then the oil pressure fuel injection pipe rises, Other causes traffic jams hole not increase, but close slinger shed oil spray holes will splash outside the slinger cause oil leakage. Solution: time to clear the injector spray holes through the tube is blocked, and regular periodic check the injector tube, if there is blockage of the spearhead, should be promptly cleaned up. Note: to clear the injection hole is soft tools should be used to clean up, so as to avoid a hard object on the injection hole damage. Case 2: Analysis: The current degree of opening is larger, the fuel injection quantity (after) Watts throttle adjustment will also increase, so the oil will be displaced to the outside of the hollow shaft and then splash slinger from the spray holes, from Felt oil seal leak out. Solution: proper throttle adjustment is small, this will be a corresponding reduction in the fuel injection quantity. Note: adjust the throttle should be performed by an experienced person to carry out, because once the throttle is closed too small will cause insufficient amount of oil on the bearings cause friction increases, the sharp rise in the temperature of a large tile, if not promptly treated will make large tile burned. www.zzzhuoli.com copper processing equipment www.zhuoli168.com autoclaved aerated concrete equipment, aerated concrete block equipment www.zhuoli888.com aerated block device aerated block cutting machine www.zhuoli668.com uncoiler www.zljxgs .com aerated concrete equipment www.zhuoli666.com aerated brick equipment